1 Install

1

2

3

4

5

 

2 Connect

1

2

3

4

5

 

Simple

This unit can perform 2.0 to 11.2-channel surround playback. This page provides the speaker installation procedure for the 7.1-channel playback using surround back speakers as an example.

FL SW FR

 

C

 

22 – 30˚

90 – 110˚

135 – 150˚

 

SL

SR

 

Listening

 

position

SBL SBR

Speakers

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the this unit, and be sure to interconnect the channels and polarities correctly.

Connecting the speaker cables

Peel off about 0.03 ft/10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.

NOTE

•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sidestoucheachother(vpage134“Protection

Circuit”).

•Never touch the speaker terminals while the power supply is connected. Doing so could result in electric shock.

•Use speakers with the speaker impedances shown below.

Speaker terminals

Speaker

impedance

 

FRONT

 

CENTER

 

SURROUND

4 – 16 Ω

SURR. BACK / AMP ASSIGN

 

F.HEIGHT / AMP ASSIGN

 

F.WIDE / AMP ASSIGN

 

Use speakers where one speaker has an impedance of 4 to 16 Ω.

version

version Basic

version Advanced

FL Front speaker (L)

FR Front speaker (R)

CCenter speaker

SW Subwoofer

SL Surround speaker (L) SR Surround speaker (R) SBL Surround back speaker (L) SBR Surround back speaker (R)

•Install the surround speakers in a position 2 to 3 ft (60 to 90 cm) higher than ear level.

 

 

 

 

Surround

 

 

 

Front

speaker

 

Surround back

 

 

 

 

 

 

 

 

 

 

speaker

 

 

 

 

 

 

 

 

speaker

2 – 3 ft /

 

 

 

 

 

 

 

 

• Point slightly

 

 

 

 

 

 

 

 

 

 

 

60 – 90 cm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

downwards

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When using a banana plug

Tighten the speaker terminal firmly before inserting the banana plug.

When using a speaker with impedance of 4 Ω or 6 Ω, make sure to set the “Speaker Impedance” in the menu (vpage 98) to “6 Ω/ohms” or “4 Ω/ ohms”.

GViewed from the sideH

The “Simple version” section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back speakers.

5

For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 54 .

 

Information