DirecTV DVR40, DVR120 manual Performing a Code Search, 112

Models: DVR40 DVR120

1 174
Download 174 pages 22.19 Kb
Page 122
Image 122

C h a p t e r 7

P r o g r a m m i n g t h e R e m o t e C o n t r o l

 

 

 

4.Enter a code. Use the number buttons on the remote control to enter a four-digit code (starting with the first code in the list on the screen). After you press the fourth digit of the code, the red light on the end of the remote control should flash. If it doesn’t, try the next code.

5.Test the code. Point the remote towards the TV and test the button (refer to the table):

To Test the:

TV power, volume,

TV input

A/V system power,

A/V system volume

 

and mute

 

volume, and mute

and mute

 

 

 

 

 

Press the:

TV PWR button

TV Input button

TV PWR buttons

MUTE button

 

 

 

 

 

If pressing the button works (e.g., turns the TV or A/V stereo system off, or changes the TV input), the code is correct. If it does not work, repeat steps 3 and 4 using the next code on the list. If none of the codes works, perform a code search (see below).

Performing a Code Search

If none of the codes listed allows you to control your device, a code search may detect the correct code. Performing a code search can take up to 20 minutes.

1.Prepare the remote control. Point the remote away from your DVR.

Refer to the table below and determine which two buttons to press to prepare the remote. Press and hold the buttons simultaneously for about 5 seconds (until the red light at the end of the remote lights up and stays on when you release the buttons).

To Control:

TV power, volume,

TV input

A/V system power,

A/V system volume

 

and mute

 

volume, and mute

and mute only

 

 

 

 

 

Press the:

TV PWR and

TV Input and

TV PWR and DIRECTV

MUTE and DIRECTV

 

DIRECTV buttons

DIRECTV buttons

buttons

buttons

 

 

 

 

 

112

Page 122
Image 122
DirecTV DVR40, DVR120 manual Performing a Code Search, 112