COMMUNICATION
ÊInstalling Communication Options and Control Terminals
To install the communication options and control terminals:
1.Install the appropriate connectivity card and/or necessary cable(s) and connect the cables to the appropriate location.
See Figure 18 and the following section, “Communication Options,” for detailed information.
2.Route and tie the cable(s) out of the way.
3.Continue to “Operation” on page 37 to start up the UPS.
ÊCommunication Options
The Eaton 9130 has serial communication capabilities through the USB and
The UPS supports two serial communication devices according to the following table:
Independent
Multiplexed
Communication Bay | USB |
|
|
|
|
Any connectivity card | Available | Not in use |
|
|
|
Any connectivity card | Not in use | Available |
|
|
|
NOTE You can configure relays, signal inputs, and the serial port baud rate through the front panel menus (see Table 3 on page 40).
NOTE The communication speed of the USB port is fixed at 9600 bps.
RS-232 and USB Communication Ports
To establish communication between the UPS and a computer, connect your computer to one of the UPS communication ports using an appropriate communication cable (not supplied). See Figure 18 for the communication port locations.
54 | Eaton® 9130 UPS |
