Stylus C40UX/C40SX/C20UX/C20SX | Revision A |
4.2.4 PS unit removal
1.Remove the upper housing. (Refer to Section 4.2.1)
2.Remove the ASF unit. (Refer to Section 4.2.2)
3.Disconnect the cable from the connector (CN2) on the main board using tweezers, etc.
4.Take out the 2 screws.
CN2
PS unit
C.B.S 3⋅ 6
C.B.P 3⋅ 8
Figure 4-10. Removing the PS unit
5.Pull the PS unit out while lifting up on it.
When installing the PS unit, make sure the claws are attached to the hooks on the lower housing.
Figure 4-11. Reassembling the PS unit
Blue line marking on PS cable should set top in No.1 of connector on the MAIN board.
1
2 3 4
| 5 | |
Blue line | ||
| ||
marking |
|
Figure 4-12. Connecting the PS cable(CN2)
Tightening Torque for screw
- C.B.S 3x6 | : |
- C.B.P 3x8 | : |
Disassembly and Assembly | Disassembly | 65 |