Epson MFJ-1278B manual Eas On/Off, Mode CW/RTTY/ASCII Default OFF, Easin ON/OFF, Echo ON/OFF

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS

EAS ON/OFF Mode: CW/RTTY/ASCII Default: OFF

Parameter:

ON Enables Real Time echoing of out-going CW, RTTY, and ASCII text

OFF Disables Real Time echoing of out-going CW, RTTY, and ASCII text

ECHO-AS SENT is basically the same as the EAS in AMTOR, but is a separate command from AMTOR. This command must be set independently from the AMTOR EAS command. When issued from the cmd: prompt, enables Real Time echoing of out-going CW, RTTY, and ASCII text. When EAS is ON and ECHO is OFF real time echoing of all transmitted CW, RTTY, and ASCII text is enabled.

EASIN ON/OFF Mode: AMTOR Default: OFF

EASIN controls whether the MFJ-1278B echos text that you have sent it for transmission at the instant it is sent. Normally the MFJ-1278B is configured to echo as you type, this is the default (OFF) state of this parameter.

Setting EASIN ON is useful for monitoring channel quality. If you type a few characters and they quickly echo, it usually means the link is quite good. On the other hand if it is taking a long time before the characters echo then the link is not that good.

ECHO ON/OFF Mode: All Default: ON

Parameters:

ON Characters received from the computer or terminal are echoed by the MFJ-1278B.

OFF Characters are not echoed.

This command controls local echoing by the MFJ-1278B when it is in Command or Converse Mode. Local echoing is disabled in Transparent Mode.

If you don't see your input on the display, you should set of every character you type, you should set ECHO OFF. displayed correctly, you have ECHO set correctly.

ECHO ON. If you see two copies If you see the characters you type