Epson MFJ-1278B Cwcall ssss Mode Amtor Default blank, CWidmode nn 0=nn=255 Mode Pactor Default

MFJ-1278B MULTI-MODE	OPERATIONAL COMMANDS
CWCALL ssss	Mode: Amtor	Default: blank

Where "ssss" are 15 characters sent as CW when you issue the ID character. The "ssss" text is sent following the QRA ("The name of my station is ______") signal.

CWidmode nn: 0<=nn<=255 Mode: Pactor Default 0

Should CW identification be required, the MFJ-1278B now supports 8 CW identification modes. Seven automatic modes are selected by the bit-mapped CWIDMODE parameter. Bit positions within the CWIDMODE parameter enable timed cw id, cwid on incoming events, cwid on outgoing events, and any combination of the three for a total of 7 modes.

The timed mode requires some explanation. The counter controlling the transmission of the timed CWID must be initially started at the beginning of each link with either the manual "ID" command or one of the initial CWIDMODE features selected by CWIDMODE bits 1 or 2. A fully automatic CW ID is achieved by setting CWIDMODE to 3. Reduced levels of automation are selected by other combinations. The eighth mode is manual cwid. Invoke manual CWID by issuing the "ID" command. Also see IDTIME

The CWIDMODE command in Pactor is very complex and provides several combinations of CWID. Below is an example of how CWIDMODE functions:

CWID/	On	On	On	Man./	Comments
MODE	Calling	Connect	Disc.	Auto
1				Man.	Mode 1 is manual ID only
				Only
2		IRS	IRS
3	ISS,IRS	IRS	IRS	Auto	Auto ID interval dependent on the
				ISS,	IDTIME setting
				ISR
4	ISS		ISS		If ISS does changeover, and new ISS
					disconnects, then the new ISS will ID
5	ISS		ISS	Auto	If ISS does changeover, then previous
				ISS	ISS auto ID is Disabled
				only
6	ISS	IRS	ISS,		Upon reciept of disconnect from ISS
			IRS		and the disconnect appears on IRS
					screen, the IRS will ID. After ID
					from IRS, the ISS will ID
7	ISS, IRS	IRS	IRS,	Auto	When ISS sends changeover, new ISS
			ISS	ISS,	AUTO ID enabled. Auto ID for
				IRS	previous ISS is disabled. Disconnects
					are handled the same as Mode 6