MFJ-1278B MULTI-MODE

OPERATIONAL COMMANDS

STREAMCA ON/OFF

Mode: Packet

Default: OFF

Parameters:

ON Callsign of other station displayed.

OFF Callsign of other station not displayed.

This command is used to enable the display of the connected-to station after the stream identifier. This is particularly useful when operating with multiple connections allowed. It is somewhat analogous to the use of MRPT to show digipeat paths when monitoring.

In the example below, the charaters inserted by enabling STREAMCAll are shown in bold face type.

A:K4NTA:hi howie ello ted how goes it?

B:WA7GXD:*** CONNECTED to WA7GXD Bmust be a dx record. ge lyle

Aunreal ted! fl-az no digis!

B:WA7GXD:big band opening...ge

etc.

The same sequence with STREAMCAll OFF would look like the following:

Ahi howie

hello ted how goes it?

B*** CONNECTED to WA7GXD Bmust be a dx record. ge lyle Aunreal ted! fl-az no digis!

Bbig band opening...ge

etc.

Thus, what would have looked like "B" now appears as "B:<callsign>:". This option is very useful for human operators trying to operate multiple simultaneous connections. It is probably less useful for "host" operations.

Note that, in the first example, the STREAMSWitch characters "A" and "B" with no ":" after them were entered by the operator of the TNC to switch streams for his multiple- connect QSO(s). If you intend to operate multiple connections (as opposed to having your

Page 278
Image 278
Epson MFJ-1278B manual Streamca ON/OFF, Mode Packet Default OFF