Epson MFJ-1278B manual PTOver nnn 0=nn=255 Mode Pactor Default $19, PTSend

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS

The PROfmars command causes the MFJ-1278B to set itself up for MARS operations. The MFJ-1278B sets the following parameters for MARS operation:

AUTOLF OFF

CCITT OFF

DIDDLE OFF

LFADDALT OFF

LFIGNORE OFF

MARSMODE $01

UNSHIFT OFF

RXLFNOCR ON

PTOver nnn: 0<=nn<=255 Mode: Pactor Default: $19

Parameters:

nnnWhere the n variable equals 0 <=n<=255

The PTOver character designates the Pactor changeover character. The PTOver command was addded in order to make the MFJ-1278B command set compatible with other Pactor controllers. This character initiates a control direction change in the Pactor signal.

This character can be varied from 0 to 255 decimal, for computers which may not support the default. The default is CTRL-Y. A value of 0 disables the Pactor changeover.

PTSend Mode: Pactor Immediate Command

The PTSend command is basically the same as the U1 Unproto command. Entering PTSend from the p_cmd: prompt will invoke the 100 baud unproto mode. The PTSend is to make the MFJ-1278B's Pactor command set compatible with other Pactor controllers.