MFJ-1278B MULTI-MODE

OPERATIONAL COMMANDS

STREAMDB ONOFF

Mode: Packet

Default: OFF

Parameters:

ON Double all received STREAMSWitch characters.

OFF Do not "double" received STREAMSWitch characters.

This command is used to display received STREAMSWitch characters by "doubling" them. The example below illustrates this action.

With STREAMDB on, and STREAMSWitch set to "", the following might be displayed from your MFJ-1278:

this is a test.

In this case the sending station actually transmitted

this is a test.

The same frame received with STREAMDBL OFF would be displayed as:

this is a test.

When operating with multiple connections, this is useful for differentiating between STREAMSWitch characters received from other stations and STREAMSWitch characters internally generated by your MFJ-1278B.

NOTE: The STREAMSWitch character must NOT be one of the stream letters (A - J) for this command to function properly.

STREAMSW n

Mode: Packet

Default: $7C

Parameters:

n = 0 - $FF, usually specifying an ASCII character code.

This command selects the character used by both the MFJ- 1278B and the user that a new "stream" (connection channel) is being addressed.

The character can be PASSed in CONVERS mode. It is always ignored as a user-initiated stream switch in TRANSPARENT mode, and flows through as data. This means that the

Page 279
Image 279
Epson MFJ-1278B manual Streamdb Onoff, This is a test, Streamsw n