Epson MFJ-1278B manual Packet Messages, BbRAM loaded with defaults, Was

MFJ-1278B MULTI-MODE SYSTEM MESSAGES

MFJ-1278B SYSTEM MESSAGES

This chapter describes the messages your MFJ-1278B may produce and the circumstances under which they can appear.

PACKET MESSAGES

*:J

bbRAM:LOAD WITH DEFAULTS MFJ Enterprises, Inc.

Model MFJ-1278B AX.25 Level 2 Version 2.0

RELEASE X.X.X - DATE - 32K RAM Checksum XXX

cmd:

This is the MFJ-1278B sign-on message that appears when you turn your MFJ-1278B ON or when you issue the RESET command. The MFJ-1278B updates the RELEASE number whenever the user changes the firmware. The checksum is a hex number that you can compare with the correct checksum given for the firmware version you are using.

bbRAM loaded with defaults

This message appears along with the sign-on message above if the battery backed-up RAM checksum verification fails at power-on time, causing the MFJ-1278B to load the default parameters from ROM. This will be the case the first time you turn on your MFJ-1278B.

This message also appears if the MFJ-1278B loads the defaults in response to the RESET command. If the user issues the RESET, all parameters set by the user are lost.

cmd:

This is the Command Mode prompt. When this prompt appears, the MFJ-1278B is waiting for you to issue a command. Anything you type after this prompt will be interpreted as a command to the MFJ-1278B If a monitored packet has been displayed, the prompt may not be visible, even though you are in Command Mode. You can type the redisplay-line character (set by REDISPLA) to retype the prompt.

was

Whenever you change the setting of one of the MFJ-1278B's parameters, the previous value will be displayed. This confirms that the MFJ-1278B properly interpreted your command, and reminds you of what you have done.