Epson MFJ-1278B manual Srxall ON/OFF, Start n, STatus, Status

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS

SRXALL ON/OFF Mode: AMTOR Default: ON

The MFJ-1278B will print all receivable mode S transmissions when SRXALL is on.

Taking advantage of the ability to receive an addressed mode S transmission requires SRXALL ON and a match between the address being sent and your MYSELCAL.

If SRXALL is OFF and MYSELCAL does not match the address in the received mode S transmission, the MFJ-1278B ignores the transmission.

START n Mode: All Default: $11

Parameters:

n0 - $7F, specifying an ASCII character code.

The START command selects the User Restart character, that is used to restart the output from the MFJ-1278B to the terminal after it has been halted by typing the User Stop character. You can enter the code in either hex or decimal.

The User Stop character is set by the STOP command.

If the User Restart and User Stop characters are set to $00, software flow control to the MFJ- 1278B is disabled, and the MFJ-1278B will only respond to hardware flow control (CTS).

If the same character is used for both the User Restart and User Stop characters the MFJ- 1278B will alternately start and stop transmission upon receipt of the character.

STatus Mode: Pactor Immediate Command

STATUS is an immediate command used for display of debug information. This is helpful for troubleshooting Pactor problems. If any Pactor problems occur and you are still able to talk to the MFJ-1278B, then type this command from the p_cmd: prompt. The MFJ-1278B will send the Pactor Status to the screen. Copy all displayed information on a piece of paper and call our technicians.

STATUS Mode: AMTOR Immediate Command)

The STATUS command returns diagnostic information useful for helping us help you with your problems. Please note the STATUS value when writing to us about any problems you