Epson MFJ-1278B manual Cbell ON/OFF, Off, BELL*** Connected to callsign

MFJ-1278B MULTI-MODE		OPERATIONAL COMMANDS
CBELL ON/OFF		Mode: Packet	Default: OFF
Parameters:
ON	Connect bell enabled
OFF	Connect bell disabled

This command is used to control whether an ASCII $O7 or CTRL-G (BELL) character is sent as part of the connected message.

When set ON, the bell character immediately preceeds the asterisk portion of the connected message, e.g.:

<BELL>*** Connected to: <callsign>

When CBELL is ON a tone will also be heard on the external speaker. A speaker must be connected to the SPEAKER jack in the rear panel of the MFJ-1278B, in order to hear this tone.

CBell ON/OFF Mode: Pactor Default:OFF

Parameters:

ON Allows the Connect bell to be heard over the monitor speaker.

OFF Disallows the Connect bell to be heard over the monitor speaker.

This command is exactly the same as the CBELL command used in packet. This command determines whether or not an ASCII $07 or CTRL-G (BELL) character is sent as part of the connected message. This command must be ON, if the CHObell command is to be used, otherwise the CHANGE OVER BELL will not work.

When the CBELL command is set to ON, the bell character immediately recedes the asterisk portion of the connected message, e.g.

<BELL>*** Connected to: <CALLSIGN>

When CBELL is ON, and a connect is made a tone will be heard on the external speaker. A speaker must be connected to the SPEAKER jack on the rear panel of the MFJ-1278B, in order to hear this tone.