MFJ-1278B MULTI-MODE

BASIC OPERATION

is proper Pactor etiquette. If you access your Mailbox via the SYsop command, then you must issue a CTRL-C to exit the Mailbox and return to command mode. The SYSOP mode is accessed through the Packet mailbox, as mentioned earlier in this section. The command prompt will indicate the stream you are on. The command prompt may look like this:

Acmd: where A indicates that you are on packet stream A.

To re-enter the Pactor mailbox you would type the following from the cmd: prompt:

PACTOR <ENTER>

This is the only way the remote users can access your Mailbox.

Mailbox Messages

You have new mail!

Upon accessing the mailbox this message will appear if there are any new messages are addressed following the last time you logged into the mailbox.

You have mail!

Upon access to a mailbox, this message will appear if there are messages addressed to you.

?EH

This message occurs when a command issued is not understood by the mailbox. This could be out of range slot number, missing slot number where one is required, or bad command.

Cannot, not yours

This message occurs when a remote user attempts to kill a message which is not his, or he tries to read personal message by or for someone else.

?Mailbox full

This message occurs when either all of the available slots are full, or the actual message space is full. Messages must be killed to recover from this error.

Not found

This message occurs when one attempts to read or kill a non-existent message from an empty slot.

None found

A parameterless Kill or Read command did not find any messages addressed to the user.

No mail

Page 75
Image 75
Epson MFJ-1278B manual Mailbox Messages, Pactor Enter, ?Eh