Epson MFJ-1278B manual Qrt, Radio n, Randomcw ON/OFF

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS

QRT Mode: AMTOR Immediate Command

The QRT command is an immediate command is used to:

1.End a mode A "ARQ" connection

When the contact is completed and you are ready to break the link, issue QRT to break it and return the MFJ-1278B to standby/receive mode.

2.Stop a broadcast in mode B (FEC) and mode S (SELCALL)

When you're broadcast is complete type QRT to return the MFJ-1278B to standby / receive mode. Also please refer see also R

R Mode: AMTOR Immediate Command

R is equivalent to QRT. The R command returns the MFJ-1278B to standby / receive mode. Also please refer to QRT.

RADIO n Mode: All Default: 1

Parameters:

n1 - 2, Specifying the radio port to be used.

The RADIO command allows the user to select the radio ports of the MFJ-1278B. From command mode, typing RADIO 1 will cause the MFJ-1278B to select radio port 1 as the active radio port. Typing RADIO 2 will cause the MFJ-1278B to select radio port 2 as the active radio port. When initially powered up, the MFJ-1278B defaults to the radio port it was set to when last powered down.

RANDOMCW ON/OFF Mode: CW Default: OFF

Pseudo random CW is sent when in CW mode and RANDOMCW is turned ON. To terminate sending random CW, type "CTL-C" and set RANDOMCW to OFF again. The random CW is sent at the speed specified by the MSPEED command.