Epson MFJ-1278B manual XOff nn, XOn nn, XON n

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS

XOff nn Mode: Pactor Default: ^S

Parameters:

nn= 0 <= nn <= 25

This command determines the Flow Control STOP character. The Pactor XOFF command is the same as the XOFF command in the standard MFJ-1278B command set. For further information on the XOFF command please refer to the explanation of the XOFF command in Chapter 6 of the MFJ Data Controller Main Instruction Manual.

XOn nn Mode: Pactor Default: ^Q

Parameters:

nn= 0 <= nn <= 255

This command determines the Flow Control START character. The Pactor XON command is the same as the XON command in the standard MFJ-1278B command set. For further information on the Pactor XON command please refer the explanation of the XON command in Chapter 6 of the MFJ Data Controller Main Instruction Manual.

* see discussion above for more on XON/XOFF software flow control

XON n Mode: All Default: $11

Parameters:

n0 to $7F, specifying an ASCII character code.

This command selects the MFJ-1278B Restart character, which is sent by the MFJ-1278B to the computer or terminal to restart input from that device. You can enter the code in either hex or decimal.

This character would ordinarily be set to <CTRL-Q> for computer data transfers. If you are operating your station in Converse Mode, and there is some chance that you might fill up the MFJ-1278B's buffers, you might set this character to <CTRL-G> ($07), which rings a bell on many terminals.