CHAPTER 8: DEBUGGER

gr (go after reset CPU)

Function

This command executes the target program from the boot address after resetting the CPU.

Format

 

 

>gr [<address1> [<address2>]]↵

(direct input mode)

<address1–2>: Temporary break addresses; hexadecimal or symbol (IEEE-695 format only)

Condition:

0 ≤ address1(2) ≤

last program memory address

Operation

This command resets the CPU before executing the program. This causes the PC to be set at address 0x0110, from which the command starts executing the program.

Once the program starts executing, the command operates in the same way as the g command, except that the gr command does not support the function for restarting execution by hitting the [Enter] key. Refer to the explanation of the g command for more information.

Notes

•If a break condition is met, program execution is suspended and the PC will be set to the program address at the breakpoint.

•The address you specified must be within the range of the program memory area available with each microcomputer model.

An error results if the input one is not a hexadecimal number or a valid symbol.

Error : invalid value

(no such symbol / symbol type error)

An error results if the limit is exceeded.

Error : Address out of range, use 0-0xXXXX

GUI utility

[Run Go from Reset] menu item, [Go from Reset] button

When this menu item or button is selected, the gr command is executed.

[Go from Reset] button

S5U1C63000A MANUAL

EPSON

179

(S1C63 FAMILY ASSEMBLER PACKAGE)