Epson S5U1C63000A manual 253

	CHAPTER 8: DEBUGGER
Error message	Content of message (Commands involved)
Incorrect register name,	The specified register name is invalid. (rs)
use PC/A/B/X/Y/F/SP1/SP2/EXT/Q
Input address does not exist	Attempt is made to clear a break address that has not been set. (bp)
invalid command	This is an invalid command. (All commands)
invalid data pattern	The input data pattern is invalid. (bd, br)
invalid file name	The file name (extension) is invalid. (lo)
invalid value	The input data, address or symbol is invalid. (All commands)
Maximum nesting level(5) is exceeded,	Nesting of the com/cmw command exceeds the limit. (com, cmw)
cannot open file
MLA address out of range, use 0–0xFFF	MLA address is invalid. (od)
no such symbol	There is no such symbol. (All symbol support commands)
no symbol information	No symbol information is available since the ".ABS" file has not
	been loaded. (sy)
Number of passes out of range, use 0–4095	The specified pass count for sequential break is out of range. (bs)
Number of steps out of range, use 0–65535	The specified step count is out of range. (s, n)
SO address out of range, use 0–0x1FFF	SO address is invalid. (od)
SP1 address out of range, use 0–0x3FF	The specified SP1 address is out of range. (bsp)
SP2 address out of range, use 0–0xFF	The specified SP2 address is out of range. (bsp)
symbol type error	The specified symbol type (program/data) is incorrect.
	(All symbol support commands)
Warning message	Content of message (Commands involved)
Break address already exists	Attempt is made to set an already-set break address. (bp)
Identical break address input	Input command contains identical address.
round down to multiple of 4	Watch data address is invalid. (dw)
User cancel	Command is aborted by the user. (xfer/xfers, xfwr/xfwrs, xfcp/xfcps)
Verify error	FPGA verify error. (xfcp/xfcps)

S5U1C63000A MANUAL	EPSON	239
(S1C63 FAMILY ASSEMBLER PACKAGE)