Epson S5U1C63000A 8.9.9 Break, 1. set, (2) >bp↵, 2. clear, 3. clear all, (guidance mode), ... ? <1 | 2 | 3>↵, (direct input mode), bp (break point set)

CHAPTER 8: DEBUGGER

8.9.9 Breakbp (break point set)

Function

This command sets or clears breakpoints using a program's execution address.

	Format
(1) >bp <break1> [<break2> [ ... <break16>]]↵						(direct input mode)
(2) >bp↵						(guidance mode)
	PC break set status
	1. set	2. clear	3. clear all		... ? <1 2 3>↵
	.......... (guidance depends on the above selection, see examples)
>
	<break1–16>: Break address; hexadecimal or symbol (IEEE-695 format only)
	Condition:		0 ≤ address ≤		last program memory address
	Examples
	Format (1)
	>bp 116 200↵			... Sets break points at addresses 0x0116 and 0x0200.
					* The direct input mode cannot clear the set break points.
	Format (2)
	>bp↵	(Set)
	No PC break is set.
	1. set	2. clear		3. clear all ...? 1↵			... "1. set" is selected.
	Set break address ? : 116↵						... Address 0x0116 is set as a breakpoint.
	Set break address ? : 200↵						... Address 0x0200 is set as a breakpoint.
	Set break address ? : ↵						... Terminated by [Enter] key.
	>bp↵	(Clear)

1:0116

2:0200

1.	set	2.	clear	3.	clear all ...? 2↵	... "2. clear" is selected.
Clear break			address	? : 200↵		... Break address 0x0200 is cleared.
Clear break			address	? : ↵		... Terminated by [Enter] key.
>bp↵		(Clear all)
	1:	0116			clear all ...? 3↵	... "3. clear all" is selected.
1.	set	2.	clear	3.
>bp↵
No PC break			is set.		clear all ...? ↵	... Terminated by [Enter] key.
1.	set	2.	clear	3.

>

Notes

•The addresses must be specified within the range of the program memory area available for each microcomputer model.

An error results if the input one is not a hexadecimal number or a valid symbol.

Error : invalid value (no such symbol / symbol type error)

An error results if the limit is exceeded.

Error : Address out of range, use 0-0xXXXX

•An error results if you attempt to clear an address that has not been set.

Error : Input address does not exist

•For direct input mode, an error results if you attempt to set breakpoints at more than 16 locations at a time. But for guidance mode, there is no such limitation, so you can specify more than 16 breakpoints before terminating the command by the [Enter] key.

•You can use this command for multiple times to set new breakpoints.

184	EPSON	S5U1C63000A MANUAL
		(S1C63 FAMILY ASSEMBLER PACKAGE)