CHAPTER 8: DEBUGGER

>tm↵

 

 

 

Single delay mode

 

Trigger Address

: 0116

 

Position: Middle

 

 

1.normal

2.single delay 3.address area ...? 3↵

... [2. address area] is selected.

Trigger address

? :116↵

... Trigger address is input.

1.in area

2.out area ...? 1↵

... In/out is selected.

Start address ?

110↵

... Address range is input

End address ? 200↵

in up to 4 locations.

Start address ?

↵

... Terminated by [Enter] key.

>

If you enter the [Enter] key only, the command will be canceled.

However, if more than one pair of addresses is specified after selecting the address-area trace mode (one pair of addresses is specified in the above example), the range of specified addresses will be set as the trace area.

Notes

•The trigger addresses set here are marked by the letter "T" at the beginning of the address lines displayed in the [Source] window.

•The address you specified must be within the range of the program memory area available with each microcomputer model.

An error results if the input one is not a hexadecimal number or not a valid symbol.

Error : invalid value

(no such symbol / symbol type error)

An error results if the limit is exceeded.

Error : Address out of range, use 0-0xXXXX

GUI utility

[Trace Trace Mode Set …] menu item

When this menu item is selected, a dialog box appears allowing selection of a trace mode.

Select a trace mode using the radio button.

Enter addresses and/or select an option and then clock [OK].

Single-delay trace mode

Normal trace mode

Address-area trace mode

S5U1C63000A MANUAL

EPSON

215

(S1C63 FAMILY ASSEMBLER PACKAGE)