Important Alert Items
Task | Alert message | Page |
|
|
|
Installation | Before moving the drive, remove the optical disk cartridge. If the drive is | |
moved with the optical disk cartridge loaded in it, the head may move |
| |
|
| |
| back and forth in the drive to damage the head or disk and reading the |
|
| data may fail |
|
|
|
|
| 1) The user must not change the settings of terminals not described in | |
| this section. The terminals must remain as set when shipped. |
|
| 2) Do not change terminal settings when the power is on. |
|
| 3) To strap setting terminals, use the jumper shipped with the drive. |
|
|
|
|
| 1) Make sure that the system power is off. | |
| 2) Do not connect or disconnect any cable when the power is on. |
|
|
|
|
| 1) Be careful of the insertion directions of SCSI connectors. For a | |
| system in which the terminating resistor power is supplied via the |
|
| SCSI cable, connecting connectors in the wrong direction may cause |
|
| the following: |
|
| The overcurrent protection fuse of the terminating resistor power |
|
| supply (SCSI device) may blow when power is turned on. |
|
| The cable may burn if overcurrent protection is not provided. |
|
| 2) Be careful of cable connector positions when connecting more than |
|
| one SCSI device. The SCSI device having the terminating resistor |
|
| must be connected to the end of the cable. |
|
| 3) The cables must be kept away from the rotating part of the spindle |
|
| motor. |
|
|
|
|
| Before demounting the optical disk drive, turn off the system power. Do | |
| not remove screws securing the cables and drive when the power is on. |
|
|
|
|
Cleaning cartridge | Device Damage: Be sure to use the dedicated head cleaner shown | |
| above. |
|
|
|
|
| Disk damage: To clean a disk, use the cleaning solution and cleaning | |
| cloth specified in Table 5.2. |
|
|
|
|
| Disk damage: Do not use this cleaning kit on a floppy disk or an | |
| optical disk cartridge to be used on other optical disk drives. |
|
|
|
|
| Disk damage: Clean a cartridge in a | |
| Fujitsu recommends wearing disposable gloves during cleaning so that |
|
| no fingerprints are left on a disk. |
|
|
|
|
| Disk damage: Do not press hard or apply excessive shock to an optical | |
| disk cartridge case while setting it in the setting case. |
|
|
|
|
| Eye inflammation: If the cleaning solution gets into your eyes, | |
| immediately wash the solution away with water. |
|
|
|
|
Maintenance and Repair | Data loss: For a repair request, you normally do not need to include | |
| any optical disk cartridge with an optical disk drive. However, you do |
|
| need to include a cartridge if errors keep occurring with a specific |
|
| cartridge. In such a case, be sure to save data stored in the cartridge |
|
| before sending it in. Fujitsu shall bear no responsibility for any data lost |
|
| during service or repair. |
|
|
|
|
vi |
