Fujitsu MCP3130SS, MCP3064SS manual Mounting, Checks before mounting the drive, Setting checklist

Installation

4.4 Mounting

4.4.1 Checks before mounting the drive

Setting switch

CNH1

Before mounting the optical disk drive in the system cabinet, check whether the setting switches and terminals are set correctly.

Table 4.8 shows the checklist.

Table 4.8 Setting checklist

	Setting item	Setting on:	Default	Check
1	SCSI ID			(SCSI ID= )
		SW1-01	OFF	o OFF	o ON
		SW1-02	OFF	o OFF	o ON
		SW1-03	OFF	o OFF	o ON
2	SCSI data bus parity check	SW1-04	ON	o OFF	o ON
3	Write cache mode	SW1-05	OFF	o OFF	o ON
4	Device type mode	SW1-06	ON	o OFF	o ON
5	Spindle automatic stop mode	SW1-07	ON	o OFF	o ON
6	Factory test mode	SW1-08	OFF	o OFF	o ON
	(user setting inhibited)
	Setting item	Setting on:	Default	Check
1	Supplied from both ODD and	CNH1 1-2	Short	o Short	o Open
	TERMPWR pin.	CNH1 3-4	Short	o Short	o Open
2	Supplied from ODD	CNH1 1-2	Short	o Short	o Open
		CNH1 3-4	Short	o Short	o Open
3	Supplied from TERMPWR pin.	CNH1 1-2	Short	o Short	o Open
		CNH1 3-4	Short	o Short	o Open

Terminating resistor

	Check item			Check
1	Drive location on SCSI bus	o	Other	o Either
			than end		end
2	SCSI terminating resistor mode (CNH1 5-6)
		o Open		o Short

4-12 C156-E228-02EN