Fujitsu MCP3130SS, MCP3064SS, MCM3064SS, MCM3130SS Example of bus phase transition on execution

Contents

Figure 5.2	Inserting an optical disk cartridge	5-3
Figure 5.3	Removing an optical disk cartridge	5-5
Figure 5.4	Appearance of optical disk cartridge	5-7
Figure 5.5	Write protect tab	5-8
Figure 5.6	Opening a shutter	5-11
Figure 5.7	Setting an optical disk cartridge into the setting case	5-12
Figure 5.8	Placing the setting case cover	5-12
Figure 5.9	Cleaning of disk surface	5-13
Figure 6.1	Revision label	6-3
Figure 6.2	Revision number indication	6-4
Figure 7.1	Example of SCSI configuration	7-2
Figure 7.2	Interface signals	7-3
Figure 7.3	DATA BUS and SCSI ID	7-4
Figure 7.4	SCSI interface connector (ODD side)	7-6
Figure 7.5	SCSI interface connector (cable side)	7-7
Figure 7.6	SCSI interface connector pin assignments (single-ended type)..	7-8
Figure 7.7	Connection of interface cable	7-10
Figure 7.8	SCSI termination circuit	7-12
Figure 7.9	BUS FREE phase	7-19
Figure 7.10 ARBITRATION phase		7-21
Figure 7.11	SELECTION phase	7-23
Figure 7.12	RESELECTION phase	7-25
Figure 7.13 INFORMATION TRANSFER phase (phase control)		7-27
Figure 7.14	Transfer in asynchronous mode	7-29
Figure 7.15	Transfer in synchronous mode	7-32
Figure 7.16	Data transfer rate in asynchronous mode	7-34
Figure 7.17	Data transfer rate in synchronous mode	7-35
Figure 7.18	Switching direction of transfer over the data bus	7-38
Figure 7.19	ATTENTION condition	7-42
Figure 7.20	RESET condition	7-44
Figure 7.21	Bus phase sequence	7-46
Figure 7.22	Example of bus phase transition on execution
	of a single command	7-48

xiv C156-E228-02EN