Using
Caution: To temporarily use your changes, press the
Recalling Factory Settings
Factory settings are those settings preselected at the factory. To recall (reset) the factory Recalling Factory Settings
Factory settings are those settings preselected at the factory. To recall (reset) the factory
settings, select the 
button or the 
button.
Options under the MACRO, INSTALL, and ADJUST functions are all initialized to the factory settings.
Using the Diagnostic Functions
The TESTS function allows you to diagnose the printer with the following two functions:
•
•
These functions are used for checking print quality and diagnosing printer problems. Hex dump also provides useful information for programmers. There are two other options in the TESTS function, but they are restricted to the use of service personnel.
Printing Test
The printing test function prints test pages independently of your computer to check printing operations and quality. It does not check the interface between the computer and the printer.
The printing test prints all of the characters available in the ASCII character set. For color printers with a color ribbon, printing occurs in four colors.
To start the printing test, make sure that continuous forms paper is loaded into the printer. Enter the
1.Start the printing test (select the PRINT-T option).
Check that the red cursor is located under 
button or
the 
button. The printer selects (underlines)
2.Exit the printing test.
Exit the printing test in either of the following ways after printing a dozen lines:
•To exit the printing test and return to the <TESTS> menu, press the 
button or
the 
button.
•To exit the printing test and return to the <FUNCTIONS> menu, press the Exit/Save button.
•To exit the printing test and return to the Normal mode (Ready), press the
