Hitachi DZ-BD70A, DZ-BD7HA instruction manual 148, Card Access

		Symptom	Cause and Correction	Reference
				page
	The remote control		Do you operate the remote control toward the remote	16
	does not operate.		control receiver of the camcorder?
			If the camcorder’s remote control receiver is exposed to
			strong light such as direct sunshine or fluorescent light,	—
			the remote control does not work.
			Adjust the position or angle of the camcorder.
			Is the lithium battery inserted in the remote control?
			Check that the polarization of the lithium battery is
			correctly set.	17
			The lithium battery may be empty. Replace the battery to
			a new one.
			Is the camcorder powered on? If not, turn on the	22
			camcorder.
	Disc cover cannot be		Is the disc correctly inserted?	33
	closed.		Remove the disc and then reinsert it.
			Connect a fully charged battery or AC adapter/charger,	21, 37
			and then turn the camcorder on and try again.
	Operating noise is		This is not a fault. A quiet operating sound is heard as the	—
	heard.		disc rotates during recording or playback, etc.
	Some vibrations are		These vibrations or sound are caused by HDD/disc drive.
	felt or slight sound is		This does not indicate a fault.	—
	heard from
	mechanism.
	•	No operation can	In the following cases, it will take more time than usual
		be performed	until operation is possible:
		because the	• Immediately after a disc or card is inserted.
		ACCESS/PC or	• When a long time has elapsed since the camcorder was
		CARD ACCESS	turned off last.
		indicator on this	• When the temperature is greatly different from the
		camcorder remains	status of previous recording.	—
		lit or flashing.	• When a scratched or dirty disc is inserted.
Additional	• After a disc or		• When the camcorder is subjected to strong vibrations.
		possible.	• When the battery or DC power cord was disconnected
		card is inserted, it
		takes some time	before turning the power switch off.
		until recording is
Information
	No image in the		• Is the LCD monitor open?
	viewfinder.		No image will appear in the viewfinder unless the LCD
			monitor is closed (default setting). You can change this	20, 40
			setting.
			• Is the camcorder set to the sleep mode?
			Press QUICK START to release sleep mode.

148