Honeywell VISTA-10PSIA Function Key Programming Overview ∗57 Menu Mode, Programming Function Keys

Installation Instructions

Function Key Programming Overview (∗57 Menu Mode)

The system provides the ability to program each of the four keypad function keys to perform one of 12 system operations. The end user can then activate the function by simply pressing and holding the programmed key for 2 seconds. Typical functions (listed below) include single-button arming, turning lights on/off, or single-button paging.

Programming Function Keys

Function key programming involves:

1.Assigning the function key number;

2.Selecting the desired function for that key.

Start Function Key Programming mode by pressing ✱57 while in Data Programming mode. The following prompts are displayed:

PROMPT

Press Key to Pgm
0 = Quit	0

VALID ENTRIES	EXPLANATION
Press the desired function key, A-D.		A	1	OFF	2	AWAY	3	STAY
NOTE: A key programmed as a function key		B	4		5		6
is no longer available to be used as an end-				MAX		TEST		BYPASS
user macro key or panic key.		C	7		8		9
[∗] to continue				INSTANT		CODE		CHECK
		D	* READY		0		#

keypad_keys-00-001-V0

Key "A" Func
Zone 95	00

Enter the desired function for this key:

00 = For the Function key selected, the function will be as follows (system default): If A selected = Zone 95 (emergency key, same as [1] [∗] pair)

If B selected = Zone 99 (emergency key, same as [∗] [#] pair) If C selected = Zone 96 (emergency key, same as [3] [#] pair) If D selected = Single-button paging

01 = Single-button paging (sends a 999-9999 message to pager)

02 = Display time

03 = Arm AWAY (reports as User 00 if closing reports are enabled)

04 = Arm STAY (reports as User 00 if closing reports are enabled)

05 = Arm NIGHT-STAY (reports as User 00 if closing reports enabled)

06 = Step Arming (arms STAY, then NIGHT-STAY†, then AWAY)

07 = Output Device Command (for device programmed as system operation type 66 in *80 Menu Mode)

08 = Communication Test (sends Contact ID code 601) 09= Macro Key (defined by [#] [6] [6] command)

[∗] to continue; returns to key number prompt with the next function key letter displayed.

† If Night-Stay zones are listed in zone list 5

5-10