HP LQH-HW 3ULQWHUV manual Complete Command List, Store Commands, Command Prefixes

Chapter 12 Complete Command List

Command Prefixes

Typing in the first portion of a command will produce an error message showing the correct syntax. For example, typing in store tcpip will produce a list of all commands that start with this prefix.

Complete Command List

	This section outlines the entire LineJet Print Server command set including
	the command syntax, a description, and, in most cases, an example for each
	command listed.
Note	If you see the word ifnum in any shell commands, you should substitute a
	1 unless directed to do otherwise. This 1 represents the one network
	interface (i.e., Ethernet) supported.

Store Commands

These commands change the settings stored in flash memory and do not affect the current or working settings in memory. A power cycle is needed before the stored settings become current.

store ifc ifnum utp [-]li [-]rx store ifc 1 utp li

Modify the physical UTP interface properties where li enables link integrity and rx enables the increased receive threshold.

store ifc from default

Set all UTP settings back to factory defaults. store ifc from current

Store all current UTP settings to flash memory so they are retained after a power cycle. This ensures all current settings match what is stored in flash memory.

store pserver opts [[-]jobsecurity] [jobtimeout seconds]

store pserver opts jobsecurity jobtimeout 5

If jobsecurity is disabled, any user can cancel queued jobs on the LineJet Print Server including guest users. If jobtimeout is set to some value other than 0, the LineJet Print Server will only wait this amount of seconds when getting printer feedback. This is only used if you have a logpath port and type set on a particular destination.

store pserver tcpsocket TCPportnumber port newTCPportnumber

store pserver tcpsocket 4000 port 5000

Change a pre-defined TCPportnumber on the LineJet Print Server to a newTCPportnumber. The default number is 9100 for prn.

220