HP LQH-HW 3ULQWHUV manual Changing Parameters, Example

Chapter 3 Changing Parameters

Changing Parameters

A configuration consists of several parameters. The factory configuration is PCL-II emulation using the Bi-Tronics interface. You can keep this configuration to print your jobs, or if your print job requires a different setting such as a serial interface, follow the procedure outlined in Table 5.

Example

The example below describes how to change the Unidirectional parameter from disable to enable. Use this example as a basic guideline to move throughout the configuration menu and change other parameters.

Figure 6 on page 41 shows the top level of the configuration menu. The submenus are shown in Chapter 4.

If the configuration has already been changed and you do not know what the current configuration is, print a copy (page 52). Then decide if you must change any parameters.

OFFLINE

CONFIG. CONTROL

* = Factory Default

. . .		PRINTER
		CONTROL
		Unidirectional		PMD Fault		Slow Paper	Power Saver
						Slew	Time
	Disable*		Enable*		Disable*		15* - 60 Min.
	Enable		Disable		Enable		Instant

	Note	Once you change active emulations, any changes to the previously
		selected emulation will be gone unless they have been saved.
			Table 5. Parameter Change Example Procedure
Step		Key		Result	Notes
1.	Make sure the printer is on. Raise the printer cover (on cabinet models).
2.		ON LINE
				OFFLINE
				CONFIG. CONTROL

48