HP LQH-HW 3ULQWHUV manual Factory Default Configuration Values, Bi-Tronics Parallel Interface

Chapter 3 Configuring The Printer

Factory Default Configuration Values

The factory default values are permanently stored in memory as a configuration and cannot be modified or erased. The configuration values for the Bi-Tronics parallel interface and Print Server (Ethernet) interface are displayed on the following pages.

Bi-Tronics Parallel Interface

ACTIVE EMULATION	PCL-II
PCL-II
Primary Char. set
ID	0
Symbol Set	Roman-8 [8U]
Pitch	10.00
Density	Data Processing
Second Char. set
ID	0
Symbol Set	Roman-8 [8U]
Pitch	10.00
Density	Data Processing
Page Length Rep.	Inches/Page
Max. Line Width	13.2 inches
Face, CPI Delay	Enable
Graphics Density	60 DPI
Perforation Skip	Disable
Display Functns	Disable
Line Terminator
LF After CR	Disable
CR After LF	Disable
CR after FF	Disable
CR After VT	Enable
PTX Linefeed	Disable
LPI Adjust	6 LPI
Page L./Lines	66 Lines
Page L./Inches	11.0 Inches
Config. Print
Symbol Set Print
Reset Cmd CFG Ld	Power Up Config
LP PLUS
Printer Protocol
P-Series
Control Code 06	8.0 LPI
Control Code 08	Elongated
Define CR Code	CR = CR
Auto LF	Disable
Overstrike	Enable
Define LF code	LF = CR + LF
Select SFCC	1
EVFU Select	Enable
Alt. Set 80-9F	Control Code
Character Set
IBM PC
Primary Subset	ASCII (USA)
Extended Subset	Code Page 437
SFCC d command	Even dot plot
CPI/LPI Select
Select CPI	10.0 CPI
Select LPI	6.0 LPI

44