HP LQH-HW 3ULQWHUV manual NetWare Version 4.x Pserver Setup, Enter Pconsole

NetWare Version 4.x PSERVER Setup

14.Select “Printer Configuration” from the next menu to display a list of configured printers.

15.Select an item from the list (e.g., either an existing printer name or a “Not Installed” one) to display the printer configuration window.

16.Assign a name (if not an existing printer) to this printer.

17.At the “Type” field, select “Remote Other/Unknown.”

18.Press ESCAPE to save the changes.

19.Press ESCAPE until back at the Print Server Configuration menu.

20.Select “Queues Serviced by Printer” to display a list of defined printers.

21.Select the printer you just defined and press ENTER.

22.At the list of queues that displays, press INSERT to add a queue to the list.

23.Select the queue defined and press ENTER.

24.When prompted for a priority, press ENTER to select the default or select a priority.

25.Press ESCAPE until you have exited PCONSOLE.

26.Reload the PSERVER.NLM that the LineJet Print Server is to service as an RPRINTER.

27.Repower the Print Server by turning the printer off and then on.

28.Wait two minutes and then check your PSERVER to see if the appropriate printer is being serviced. The PSERVER should indicate that the printer is “Waiting for job.”

At this point, the LineJet Print Server knows to receive any jobs this PSERVER.NLM has to send to it through the defined printer.

NetWare Version 4.x PSERVER Setup

LineJet Print Server destinations are case sensitive and will not be recognized if they are typed incorrectly. By default, they are all lower case. If you are setting up a NetWare 4 environment, the destination must be renamed to uppercase to match the PCONSOLE entry.

The LineJet Print Server can be used in a NetWare 4 environment with either of the following options:

•Set the LineJet Print Server up as a PSERVER, replacing a dedicated printer.

•Set the LineJet Print Server up as an RPRINTER, interacting with an existing PSERVER (see page 191).

Following a PSERVER setup, bindery emulation is required. To configure the LineJet Print Server as a PSERVER in a NetWare 4 environment:

1.Log in to the Novell as supervisor.

2.Enter PCONSOLE.

3.Press F4.

4.Select “Print Queues.”

189