HP LQH-HW 3ULQWHUV manual Printer Diagnostics Ribbon Control

		HOST				ETHERNET
		INTERFACE				PARAMS
		(see page 110)			(see page 120)
Bi-Tronics*			Serial (cont.)		IP Address
	Prime Signal		Stop Bits			xxx.xxx.xxx.xxx
	Disable*		1*		Gateway Address
	Enable		2			xxx.xxx.xxx.xxx
	TOF Action		Parity		Subnet Mask
	Reset*		None*			xxx.xxx.xxx.xxx
	Do Nothing		Odd		MAC Address
	Buffer Size in K		Even			hhhhhhhhhhhh
1* (1-16)			Mark		Novell Protocol
Centronics			Sense			Enable*
	Data Bit 8		Data Term Ready			Disable
	Enable*		True*		NetBIOS Protocol
	Disable		On-Line and BNF			Enable*
	PI Ignored		Off-Line or BF			Disable
	Enable*		False		Novell Frame
	Disable		Request to Send			Ethernet 802.2*
	Data Polarity		On-Line and BNF*			802.2 Snap
	Standard*		Off-Line or BF			Auto Sensing
	Inverted		False			Ethernet II
	Resp. Polarity		True			Ethernet 802.3
	Standard*		Buffer Size in K		PPM Port Number
	Inverted		1* (1-16)			3001*
	Busy on Strobe		Ethernet			(0-65535)
	Enable*		Buffer Size in K		PPM Port Timeout
	Disable		16* (1-16)			32 Seconds*
	Latch Data On		Auto Switching			(1-255)
	Leading*		Parallel Hotport		Ethernet Speed
	Trailing		Port Type			Auto Select*
	Prime Signal			Bi-Tronics*		10 Half Duplex
	Disable*			Centronics		10 Full Duplex
	Enable			Ethernet		100 Half Duplex
	TOF Action			Disable		100 Full Duplex
	Reset*		Trickle Time
	Do Nothing		1/4*
	Buffer Size in K			(1/4-16 sec.)
1* (1-16)				Off
Serial			Timeout
	Interface Type			10 sec.*
	RS-232*			(1-60 sec.)
	RS-422		Report Status
	Data Protocol			Disable*
	XON / XOFF*			Enable
	ETX / ACK		Serial Hotport
	ACK / NAK		Port Type
	DTR			RS-232*
	Baud Rate			RS-422
9600*				Disable
19200			Trickle Time
38400			1/4*
600				(1/4-16 sec.)
1200				Off
2400			Timeout
4800				10 sec.*
	Word Length			(1-60 sec.)
8*			Report Status
7				Disable*
				Enable

PRINTER		DIAGNOSTICS	RIBBON
CONTROL		(see page 123)	MINDER
(see page 121)			(see page 126)
Unidirectional	Printer Tests		New Ribbon
Disable*		Shift Recycle*	Ribbon Action
Enable		All E’s	Disable*
PMD Fault		E’s + TOF	Display
Enable*		All H’s	Fault
Disable		All Underlines	Ribbon Size
Open Platen @BOF		All Black	60 yards*
Disable*		Shuttle Slow	(1-255)
Enable		Shuttle Fast	Ribbon Adjust
Slow Paper Slew		Shuttle Only	0%*
Disable*		Phase Printer	(-99% to 99%)
Enable		217* (500 lpm)	Fault Action
Power Saver Time		123* (1000 lpm)	New Ribbon*
15 min.*		62* (1500 lpm)	Do Nothing
(5 sec.-60 min.)		(1 to 2000)
Disable		Paperout Adj.
Instant		Burnin Test
		Print Error Log

Clear Error Log E-Net Test Page

Test Width Full Width* 80 col.

Paper Out Dots 40 dots* (4-76 dots)

System Memory x Megabytes

Print Statistics On: x.x Hrs. Print: x.x Hrs. Print Strokes Print Lines

11 inch Pages

To view options, press:

6Down

5 Up

4Next

3Prev

To select an option, press ENTER.

To return to main menu, press

CLEAR.

To exit menu, press ON LINE. * = Default Setting

Figure 9. Configuration Main Menu (continued)

69