HP LQH-HW 3ULQWHUV manual Form Design Checklist

Appendix B Form Design Checklist

Form Design Checklist

Use this checklist to help you remember key areas of consideration when designing and ordering forms and paper stocks.

Environment

________	Before they are used, forms are given at least 24 hours of
	condensing time in the environment in which they will be used.
________	Forms are not stored in environments that result in damage such
	as delamination of glue lines, creasing, folding, etc.

Type Of Form

Form Type (Check One)

1 Part

2 Part

3 Part

4 Part

5 Part

6 Part

<---------	Carbonless Range ---------	>
<----------------------------	Carbon Range ------------------------------		>

Recycled Paper? Yes _______ No _______ If yes, assure adequate form

strength to prevent tractor holes and perforations from tearing or detaching during form feeds and page ejects.

Security Form? Yes _______ No _______ If yes, the last page of the form

should have a minimum 50% reflectance, and, if possible, the stippled page faces inward to the form.

Form Weight

Form weight = ________

(Minimum = 15 lb. / 6.8 kg ; Maximum = 100 lb / 45.36 kg)

Form Thickness

Form thickness = ________

(0.025 inches / 0.0635 cm maximum measured at the thickest point of the form, which includes perforations, compressed staples, glue lines, etc.)

Form Evenness

The evenness of the form = ________

(Not to exceed 0.003 in. / 0.00762 cm)

Tenting due to buildup of perforation thickness must be minimized. A perforation thickness measured at the major perforation that exceeds 1.25 times the forms thickness measured in the print area will result in an unreliable and unpredictable form. Perforation thickness must not exceed the maximum form thickness of 0.025 in. / 0.0635 cm.

282