HP LQH-HW 3ULQWHUV manual Put filename.prg Return

Loading Code Through The Ethernet Port Using ftp

8.Log in to the printer and at the user prompt type: root<Return>

Default is no password. If the ftp program prompts you for a password, contact the system administrator.

9.When you are logged in, type the following sequence at the DOS prompt to download filename.prg to the printer:

cd dest<Return>

	cd d4prn<Return> (Use d4prn to avoid potential conflict with
	backchannel if d1prn is used.)
	bin<Return>
	put filename.prg<Return>
Caution	Do not interrupt the downloading process once it has started.
	Interrupting a download will damage the flash memory on the
	controller board and Print Server card.

10.As the file downloads, the ftp program shows the progress as a percentage, as does the display on the control panel of the printer. When the download is complete, the printer will be placed ONLINE. Exit the ftp program by typing:

quit<Return>

11.When the new program has successfully loaded into flash memory and the printer has reset itself and is ONLINE / E-Net Ready, reconfigure the printer using the configuration printout(s) you made in step 1. Remember to designate the correct Power On configuration.

Note	If the ON LINE key is pressed before the display reads “E-Net Ready,” the
	Ethernet PCA may not initialize properly, resulting in all zeroes for the IP
	address. In this case, power off then on and wait for “E-Net Ready” to
	display before pressing any keys.

12.Power the printer off then on to verify the correct saved configuration loads at power up.

13.Reconnect the printer data cable(s).

37