(). The profile remains on the appliance, but you must to correct it. When you correct the server profile, the profile status changes to OK ().

Symptom

Server profile is not created or updated correctly

Possible cause and recommendation

Prerequisites and conditions have not been met

1.Verify that the prerequisites listed in the online help have been met.

2.Verify that the following conditions are TRUE:

The profile name is unique

The selected server hardware is powered off

The server hardware is in the No Profile Applied state, has the correct firmware, and the ports are mapped to the correct interconnect

The server hardware is able to power cycle, and a user did not shut down the server hardware while the profile settings were being applied

You applied the correct iLO and ROM firmware levels

You are using supported server hardware

The environment has been configured

The iLO has an IP address and network connectivity

Communication exists with the server hardware iLO, including but not limited to whether the iLO is functioning, network cabling is connected and functional, and there are no problems with switches or interconnects in the management network

The add enclosure operation successfully completed

The OA has network connectivity

The add server hardware operation successfully completed

The specified network or network set is available on the server hardware port

The interconnects are in the Configured state, and have the correct firmware

The logical interconnect configuration matches its logical interconnect group definition

There are no duplicate networks on a physical port

If multiple adapters are installed, all adapters must have the same firmware version

User-specified addresses are unique and have correct format

3.When the issues have been addressed, either edit the profile or delete the profile and create another profile.

Server profile has duplicate networks on the same physical port

Change the connection to a different port.

Change the connection to use a different VLAN.

Server profile fails The following conditions have not been met to add connection

The interconnects are in the Configured state, and have the correct firmware

The servers are in No Profile Applied state, have the correct firmware, and the ports are mapped to the correct interconnect

216 Troubleshooting

Page 216
Image 216
HP OneView manual Prerequisites and conditions have not been met