Intellifont SIMM

Increasing the Disk Cache Size

If your printer has more than 12 MB of RAM, the size of the disk

cache is adequate.

If your printer has 12 MB of RAM, you must do one of the following to use the Intellifont fonts:

nAdd 48 KB to the disk cache (Administration/Memory/Disk Cache menu).

»Note: You may need to decrease one of the other memory clients before increasing the disk cache client.

nEnable disk swapping (Administration/Memory/Enable Disk Swap menu) if a hard disk is available–this automatically increases the size of the disk cache to 256 KB.

nAdd more printer memory, which automatically increases the size of the disk cache. See “Single In-Line Memory Modules,” earlier in this chapter.

Verifying the Installation

Once you have installed the Intellifont SIMM, print a start-up page and an advanced status page to verify the installation.

1Wait for the printer message window to display IDLE.

2If necessary, use the Administration/Startup Options/Startup Page menu to enable start-up pages.

3Turn the printer off and back on again.

In the Options section of the start-up page, the items %car- tridge% and %cartridge1% verify the installation of the SIMM. (Both items appear even though you’ve installed only a single option.)

4If necessary, use the Administration/Special Pages/Status Page Type menu to change the default Standard setting to Advanced.

5Press the Status Page key to print an advanced status page.

6-32

QMS 1660E Print System Reference