HP QMS 1660E manual 51

Emulations

Default Font Index

Sets the default font index when Select by Index is chosen in the Administration/Emulations/PCL 5/Default Font menu. If a font by the same index number exists, it is selected as the default font. This font must be a cartridge or downloaded soft font.

Menu Administration/Emulations/PCL 5/Default Font Idx

Choices 00000-32767

Default Depends on cartridge or downloaded font(s)

Download Location

Controls the default storage location of PCL objects (fonts, macros, and patterns).

Menu	Administration/Emulations/PCL 5/Downld Location
Choices	Disk—All downloaded PCL objects are stored on the default
	disk, if present. These objects remain on the disk even if
	the printer power is turned off.
	Memory—All downloaded PCL objects are stored in temporary
	storage in RAM.
Default	Disk
Notes	DOC commands specifying resources override this option on a
	per-job basis.
	If this option is set to Disk and no hard disk is installed,
	memory is used as the default storage location.
	If the printer has both a hard disk and a large amount of
	memory, setting this option to Memory enhances printer
	performance.
	Before you download any objects, ensure that the printer has
	enough memory, or they may not be available for use. If it
	doesn’t, you can install SIMMs (see chapter 6, “Printer
	Options”) to increase printer memory, or you can install a hard
	disk (see chapter 6, “Printer Options”) and enable disk
	swapping (Administration/Memory/Enable Disk Swap menu–
	see the “Memory” section, later in this chapter).

Printer Configuration 4-19