Storage

Options

Removing an IDE-SCSI Board

Use the following instructions if you ever need to remove an IDE- SCSI board from the printer (for example, if you decide to install an optional IDE internal hard disk after the IDE-SCSI board is already installed).

Illustrations are not included with this procedure. However, you can use the appropriate illustrations in the previous section, “Installing an IDE-SCSI Board.”

MWARNING! Turn off the printer and unplug the power cord before taking the cover off the printer.

ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.

Caution: It's very important to protect the printer controller board from electrostatic damage while performing this task.

If an anti-static wrist strap is provided in your printer option kit, attach one end of it to your wrist and the other end to any convenient electrical ground (for example, the bare metal chassis of equipment, as on the back of a computer, that is plugged in but turned off). Never attach the wrist strap to any piece of equipment with an electrical current present. Turn off all power switches first. Plastic, rubber, wood, painted metal surfaces, and telephones are not acceptable grounding points. The printer isn't an acceptable grounding point either because it must be unplugged before you perform this task.

If you don't have an anti-static wrist strap, discharge your body's static electric charge by touching a grounded surface before you handle any printer boards or components and before removing the controller board cover. Redischarge your body’s static electric charge each time after walking around and before touching the printer controller board again.

6-60

QMS 1660E Print System Reference