Running dsktune

7. Troubleshooting

7.1. Running dsktune

dsktune runs when the Directory Server is first set up to check for minimum operating requirements. After the setup, the dsktune utility can determine the Directory Server patch levels and kernel parameter settings. To launch dsktune, Directory Server has to be installed successfully first.

NOTE

You must run dsktune as root.

On Solaris, dsktune automatically checks the patches and compares them with the current Sun recommended patch lists. If it detects that the system is missing an important patch, dsktune will notify you, even if the patch is for package that is not installed yet.

The command to run dsktune is as follows:

/usr/bin/dsktune

The dsktune utility then scans the system for required patches and dependencies.

Red Hat Directory Server system tuning analysis version 10-AUGUST-2007.

NOTICE : System is i686-unknown-linux2.6.9-34.EL (1 processor).

WARNING: 1011MB of physical memory is available on the system. 1024MB is recommended for best performance on large production system.

NOTICE : The net.ipv4.tcp_keepalive_time is set to 7200000 milliseconds (120 minutes). This may cause temporary server congestion from lost client connections.

WARNING: There are only 1024 file descriptors (hard limit) available, which limit the number of simultaneous connections.

WARNING: There are only 1024 file descriptors (soft limit) available, which limit the number of simultaneous connections.

Example 7.1. dsktune Output

105