HP UX Red Hat Direry Server Software manual Express Setup Typical Setup Custom Setup

Chapter 3. Setting up Red Hat Directory Server on Red Hat Enterprise Linux

ls *.rpm egrep -iv -e devel -e debuginfo xargs rpm -ivh

2.After the Directory Server packages are installed, run the setup-ds-admin.plscript to set up and configure the default Directory Server instance and the Administration Server.

/usr/sbin/setup-ds-admin.pl

3.Accept the licensing agreement.

4.On the next screen, review the dsktune output. If there are any issues that you should address, exit the setup-ds-admin.plprogram, and resolve them. Otherwise, accept the output.

5.Select the setup type, and proceed with configuring the new Directory Server instance.

•Section 3, “Express Setup”

•Section 4, “Typical Setup”

•Section 5, “Custom Setup”

NOTE

Directory Server version 8.0 conforms to the Filesystem Hierarchy Standards. This means that the directories and files are in different locations than previous versions. For more information on FHS, see the http://www.pathname.com/fhs/ homepage. For a table showing the new file locations, see Section 1, “Directory Server File Locations”.

3. Express Setup

Use express installation if you are installing Directory Server for an evaluation or trial. Because express installation does not offer the choice of selecting the Directory Server server port number or the directory suffix, among other settings, Red Hat recommends not using it for production deployments.

NOTE

The setup program gets the host information from the /etc/resolv.conf file. If

32