HP WaterSkis E1412A, WaterSkis E1312A manual ESE and *ESE?, Example Enable All Error Events

*CLS

*CLS clears the Standard Event Status Register, the Operation Status Register, the Questionable Signal Register, and the error queue. This clears the corresponding summary bits (3, 5, and 7) in the Status Byte Register. *CLS does not affect the enable unmasks of any of the Status Registers.

Comments •

•

•

•

Executable when Initiated: Yes

Coupled Command: No

Related Commands: STATus:PRESet

*RST Condition: none

*ESE and *ESE?

*ESE <unmask> enables (unmasks) one or more event bits of the Standard Event Status Register to be reported in bit 5 (the Standard Event Status Summary Bit) of the Status Byte Register. <unmask> is the sum of the decimal weights of the bits to be enabled allowing these bits to pass through to the summary bit ESB (bit 5 in the status byte).

*ESE? returns the current enable unmask value.

Parameters

Parameter Name	Parameter Type	Range of Values	Default Units
<unmask>	numeric	0 through 255	none

A 1 in a bit position enables the corresponding event; a 0 disables it.

Comments • Executable when Initiated: Yes

•Coupled Command: No

•Related Commands: *ESR?, *SRE, *STB?

•*RST Condition: unaffected

•Power-On Condition: no events are enabled

Example Enable All Error Events

*ESE 60 Enable error events.

Chapter 3 Multimeter Command Reference 163