Husqvarna 320, 330X Installing and connecting the charging station

English - 19
INSTALLATION
Do not, under any circumstances, mount the transformer
at a height where there is a risk it can be submerged in
water (at least 30 cm from the ground). It is not permitted
to place the transformer on the ground.
IMPORTANT INFORMATION
Use the transformer’s plug to disconnect
the charging station, for instance before
cleaning or repairing the loop wire.
Installing and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Tilt the protective cover on the charging station
forward and connect the low voltage cable to the
charging station.
3. Connect the transformer’s power cable to a 110-
230 V wall socket.
4. Attach the charging station to the ground using
the supplied screws. Ensure the screws are
screwed all the way down in the countersink. If
the charging station is placed against a wall, it is
best to wait before securing the charging station
to the ground until after all the wires have been
connected.
IMPORTANT INFORMATION
It is not permitted to make new holes
in the charging station’s plate. Only the
existing holes may be used to secure the
base plate to the ground.
IMPORTANT INFORMATION
Do not tread or walk on the charging
station’s plate.
3012-1063
3012-1045
3012-1090
3012-1093