Husqvarna 330X, 320 manual First start-up and calibration, Test docking with the charging station

INSTALLATION

3.8 First start-up and calibration

Before the robotic lawnmower is operated, a start-up sequence in the robotic lawnmower’s menu must be carried out as well as an automatic calibration of the guide signal.

1.Open the control panel hatch by pressing the STOP button.

2.Set the main switch to position 1.

A start-up sequence begins when the robotic lawnmower

is started for the first time. The following is requested:

•  Language •  Country •  Date

•  Time

•  Four digit PIN code. All combinations except 0000 are permitted.

Park the robotic lawnmower in the charging station and press START.

The robotic lawnmower will now begin to calibrate the cutting height adjustment. When this is complete the calibration of the guide wires is performed. Press START and close the hatch. The calibration is performed by the robotic lawnmower backing out of the charging station and running a calibration process in front of the charging station. When this is completed, mowing can begin.

IMPORTANT INFORMATION

Use Memo on page 2 to make a note of the PIN code.

3.9Test docking with the charging station

Before using the robotic lawnmower, check that the robotic lawnmower can follow the guide wire all the way to the charging station and easily docks with the charging station.

The test function is found in the robotic lawnmower’s Installation > Find charging station > Overview menu. For more information, See Overview on page 51.

If more than one guide wire is installed, the test must be carried out on all guide wires.

If no guide wire is installed the test must be carried out on the boundary wire, both clockwise and anti-clockwise.

The guide system must first be calibrated if the above test is to provide a satisfactory result. See 3.8 First start-up and calibration on page 32.

3012-NNN

English - 32