INSTALLATION

3 Installation

This chapter describes how to install the robotic lawnmower. Before starting the installation read the previous chapter 2. Presentation.

Read also through this entire chapter before beginning the installation. How the installation is done also affects how well the robotic lawnmower works. It is therefore important to plan the installation carefully.

Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see the ideal positions for the charging station, the boundary wire and the guide wire. Draw on the sketch where the boundary and guide wires should be routed.

See 7 Garden examples on page 65 for installation examples.

Visit also www.automower.com for further descriptions and tips regarding installation.

Carry out the installation as outlined in the following steps:

3.1Preparations

3.2Installation of the charging station

3.3Charging the battery

3.4Installation of the boundary wire

3.5Connecting the boundary wire

3.6Installation of the guide wire

3.7Checking the installation

3.8First start-up and calibration

3.9Test docking with the charging station

The charging station, boundary loop and guide wire must be connected to be able to carry out a complete start-up.

3.1Preparations

1.If the lawn in the working area is longer than 10 cm mow it using a standard lawnmower. Then collect the grass.

2. Fill in holes and hollows to stop rainwater forming pools of water. The product may be damaged if it is operated in pools of water. See 11 Guarantee terms on page 87.

3. Read carefully through all the steps before the

 

installation.

3012-1101

English - 15

Page 17
Image 17
Husqvarna 320, 330X manual Installation, Preparations, See 7 Garden examples on page 65 for installation examples