TROUBLESHOOTING

Outside working area

The boundary wire connections to

Check that the boundary wire is connected

 

the charging station are crossed.

correctly.

 

 

 

 

The boundary wire is too close to the

Check that the boundary wire has been laid

 

edge of the working area.

according to the instructions. See 3 Installation

 

 

on page 15.

 

 

 

 

The working area slopes too much

Check that the boundary wire has been laid

 

by the boundary loop.

according to the instructions. See 3 Installation

 

 

on page 15.

 

 

 

 

The boundary wire is laid in the

Check that the boundary wire has been laid

 

wrong direction around an island.

according to the instructions. See 3 Installation

 

 

on page 15.

 

 

 

 

Disturbances from metal objects

Try moving the boundary wire.

 

(fences, reinforcement steel) or

 

 

buried cables close by.

 

 

 

 

 

The robotic lawnmower finds it hard

Place the robotic lawnmower in the charging

 

to distinguish the signal from an

station and generate a new loop signal.

 

installation close by.

See 6.5 Security on page 45.

 

 

 

Wrong PIN code

Wrong PIN code has been entered.

Enter the correct PIN code. Contact the local

 

Five attempts are permitted, and

dealer if you forget the PIN code.

 

the keypad is then blocked for five

 

 

minutes.

 

No drive

The robotic lawnmower has got

Free the robotic lawnmower and rectify the

 

caught in something.

reason for the lack of drive. If it is due to wet

 

 

grass, wait until the lawn has dried before

 

 

using the robotic lawnmower.

 

 

 

 

The working area includes a steep

Maximum guaranteed slope is 45%. Steeper

 

slope.

slopes should be isolated. See 3.4 Installation

 

 

of the boundary wire on page 21.

 

The guide wire is not laid at an angle

If the guide wire is laid on a slope, it must be

 

on a slope.

laid at an angle across the slope. See 3.6

 

 

Installation of the guide wire on page 28.

 

 

 

Charging station

The contact between the charging

Put the robotic lawnmower in the charging

blocked

strips and contact strips may be poor

station and check that the charging strips

 

and the robotic lawnmower has made

andcontact strips make good contact.

 

a number of attempts to charge.

 

 

 

 

 

An object is obstructing the robotic

Remove the object.

 

lawnmower.

 

 

 

 

Stuck in charging

There is an object in the way of the

Remove the object.

station

robotic lawnmower preventing it from

 

 

leaving the charging station.

 

 

 

 

Upside down

The robotic lawnmower is leaning too

Turn the robotic lawnmower the right way up.

 

much or has turned over.

 

 

 

 

Needs manual

The robotic lawnmower is set to the

Place the robotic lawnmower in the charging

charging

Secondary area operating mode.

station. This behaviour is normal and no action

 

 

is required.

 

 

 

Next start hh:mm

The timer setting prevents the robotic

Change the timer settings. See 6.3 Timer on

 

lawnmower from operating.

page 42.

 

 

 

English - 77

Page 79
Image 79
Husqvarna 320, 330X manual Troubleshooting