
Table
State | Possible Causes | Possible Solutions |
None | The LEC is either | None required. |
| inactive or has |
|
| successfully completed |
|
| the operation. |
|
Table
State | Possible Causes | Possible Solutions |
Invalid Request | The LEC may be | Check the underlying |
Parameters | requesting a resource | media for both the |
| that is on an ELAN | ELAN and the LEC |
The LES/LECS has | which has a different | requesting the service. |
rejected a request | LAN type to the LEC. |
|
Timeout
A task could not be completed within its allotted time frame.
The software has been set up to use a LECS, but a LECS is either not present on the network or broken.
The LES for the ELAN is not functioning correctly
If there is a LECS on your network, ensure that it is operational and on part of the network that can be accessed by the ATM Module.
If a LECS is not present on the network, you must enter the LES Address for each ELAN manually using the ATM VLAN Setup Screen (see “Extending VLANs into the ATM Network” on page
Contact Technical Support.
from the LEC |
|
|
because the request | The frame size used | Check the frame sizes |
parameters were | could be wrong. | being used. |
incompatible with |
|
|
the ELAN. |
|
|
Duplicate LAN | The LES has received a | Ensure that MAC |
Destination | request from a LEC | addresses are unique. |
| which contains a MAC |
|
A destination source | address already |
|
MAC address | registered to another |
|
duplicates a | LEC on the same ELAN. |
|
previously registered |
|
|
MAC address. | You may have |
|
| accidentally entered the |
|
| same MAC addresses |
|
| twice. |
|
(continued) |
|
|
Undefined Error | Unknown. | Contact Technical |
An error has |
| Support. |
|
| |
occurred but no |
|
|
cause can be |
|
|
identified. |
|
|
Version Not | The LANE services you | Ensure that the LANE |
Supported | are trying to connect | Services use LANE 1.0. |
LANE 1.0 not | to, do not support |
|
LANE version 1.0. |
| |
supported. |
| |
|
| |
(continued) |
|
|