IBM CF Series manual SET CCB Registers a, Test Frame Grabber B

5.1.10 SET CCB REGISTERS (A)

“Set CCB registers” allows you to view and alter the contents of the registers on the CCB (Camera Controller Board). These registers store the parameters controlling the function of the camera.

When you press <A> for “Set CCB Registers”, the prompt, “Do you want to initialize CCB Board? Type “Y” (yes), or “N” (No)-->,”appears.If you press <Y>, the registers will be cleared of their current and reset to the values stored on the Non-volatile RAM (NVRAM) on the CALS Board. If you press <N>, the current values will be retained until you change them or the scanner is turned off. In either case, the operative values will be displayed as shown in figure 5-25.

	----- SET CCB REGISTERS -----
00	Expsr Timer	Low : FF		08	Expsr Timer High : FF
10	Camera Enables : 70
20	Merge 0: 00			21	Merge 1: 5E
22	Merge 2: 4D			23	Merge 3: 34
24	Merge 4: 5C			25	Merge 5: 10
26	Merge 6: 26			27	Merge 7: 7C
28	Merge 8: 80			29	Merge 9: 00
2A	Merge A: 00			2B	Merge B: 00
2C	Merge C: 00			2D	Merge D: 00
2E	Merge E: 00			2F	Merge F: 00
30	Window Start Low		: 18	34	Window Start High : 02
38	Window Width Low		: EA	3C	Window Width High : A1
40	Interface Status: 6F			50	CCB Control/Stat: 00
60	Int Cntrl(writeonly)			70	Line Scan Delay : 00
	S = SET	X = EXIT		CHOICE =
				Ready

Figure 5-25 Set CCB Registers Menu

5.1.11TEST FRAME GRABBER (B)

This option allows you to test the Frame Grabber section of the display board which creates the image seen on the display monitor. When you select this option, a pattern of boxes will fill the display of monitor so you can check the screen for squareness and centering. On the scanner control terminal, the prompt, “Hit any key to exit,” appears. Entering any key will return you to the Diagnostic Tests menu.