IBM manual Diagnostic Software, On-Board Diagnostic System, 7 CF Series Scanner Main Menu

5 DIAGNOSTIC SOFTWARE

5.1 On-Board Diagnostic System

The Main Menu shown in Figure 5-7 is typical for a CF Series 1000 scanner. The Main Menus for the other CF Series Scanners are similar. The functions on the Main Menu are the same as those on the keypad and the scanner can be operated from either device.

				M A I N	M E N U
1	-	Scan		Off	3 -		Set Document Size	E
2	-	Scan Mode		Manual	4 -		Filter	Off
7	-	Diagnostic Tests			5	-	Tracking	Off
8	-	Set Resolution		1000	6 -		Positive/Negative Image +
Z -		Display Zoom In			up -		Increase Threshold	32
H -		Display Zoom Out			dn -		Decrease Threshold
X -		Select Area			R -		Scan Direction	Forward
Y -		Repeat Area			G -		Gray Scale	Off
S -		Speed	Full		I -		Fast In
F -		Binary Filter			O -		Fast Out
<- - Move Displayed Area Left					-> -		Move Displayed Area Right
					Ready

Figure 5-7 CF Series Scanner Main Menu

To access the Diagnostic Tests program form the Main Menu, press <7> and the menu illustrated in Figure 5-8 will appear. At this point, keypad control from the scanner is disabled until you exit the Diagnostic Tests program.

	DIAGNOSTIC TESTS
	----------------
1	Set Global Parameters	2	Perform System Init
3	Parameter Backup	4	Set Motor Speed
5	Splice Counts	6	Focus and Magnification
7	IP LUT	8	Merge & Splice Adjustment
9	Autosize Parameters	A	Set CCB Registers
B	Test Frame Grabber	C	Test I/O Board
D	Page Offsets	E	Camera System Diagnostics
F	Resolution Control	G	Set Document Sizes
H	Run Self Tests	I	Restore NVRAM
J	Binary Filter Parameters	K	IP Averager LUT
L	Autocalibration	M	SCSI Buffer Parameters
X	Exit
		Ready

Figure 5-8 Diagnostic Tests Menu