IBM CF Series manual Set Global Parameters, 9 Global Parameters Menu

5.1.1Set Global Parameters (1)

The Global Paramerters affect all scanner operations and will affect your entries in other menus.

When you press <1> for “Set Global Parameters,” a menu display similar to that in Figure 5-9 appears. The values shown in this example are typical for a CF Series 1000 scanner.

----- SET GLOBAL PARAMETERS -----

0		MAXIMUM RESOLUTION		1000
1		NUMBER OF CAMERAS		8
2		SPLICE ON/OFF		On
3		PIXEL SOURCE		Cameras
4	NUMBER OF RESOLUTIONS			8
5		GRAY SCALE ON/OFF		Off
6	NUMBER OF DOCUMENT SIZES			5
7		CCB WINDOW START		0258
8		DISPLAY SYSTEM		In
9			MIRROR	Off
A		DEFAULT ZOOM STATE		Zoomed In
B		AUDIO LEVEL		F
S : SET		X : EXIT	CHOICE: X
			Ready

Figure 5-9 Global Parameters Menu

If you do not want to change anything, press <X> to exit and return to the Diagnostic Tests Menu.

If you press <S> for “Set,” the prompt, “Parameter Number,” will appear. Enter the number for the parameter you wish to change and a prompt will appear, allowing you to change its value.

<0> MAXIMUM RESOLUTION: In the example, the scanner has a maximum resolution of 500 dpi. (do not alter this parameter)

<1> NUMBER OF CAMERAS: In the example shown, four cameras are installed. (do not alter this parameter)

<2> SPLICE ON/OFF: This switch controls the electronic line splice adjustment function of the CALS Board. When the scanner is received from the factory, this function is