C H A P T E R 3

Intel Express 460T Standalone Switch Users Guide

NOTE

The 460T sends BootP requests for several minutes; after that time, if no IP has been entered, the switch stops sending the request and continues to boot.

To install and configure a new switch for management

1Start Intel Device View. The Device Install Wizard appears. If it doesn’t appear, click Install from the Device menu or double-click the appropriate MAC address in the Device Tree under Unconfigured Devices. (The MAC address is located on the rear of the switch.)

2On the Device Install Wizard - Start screen, click Next.

3On the Device Install Wizard - MAC Address screen, click the MAC address of the new switch and then click Next.

4Follow the instructions in the wizard to assign an IP address and a name to the switch.

Using the Device Tree

When you start Intel Device View, the Device Discovery service begins searching for supported Intel network devices on your network. As it discovers devices, the Device Discovery service adds an icon for each device to the Device Tree on the left side of the screen.

26

Page 32
Image 32
Intel 460T manual Using the Device Tree, To install and configure a new switch for management