System Management Feature Specifications
6.1.3SMBus Device Addressing
Of the addresses broadcast across the SMBus, the memory components claim those of the form “1010XXYZb”. The “XX” and “Y” bits are used to enable the devices on the processor at adjacent addresses. The Y bit is hard-wired on the processor to GND (‘0’) for the Scratch EEPROM and pulled to 3.3V (‘1’) for the processor information ROM. The “XX” bits are defined by the processor socket via the SMA0 and SMA1 pins on the Itanium 2 processor connector. These address pins have a weak pull-down (10 kΩ) to ensure that the memory components are in a known state in systems which do not support the SMBus, or only support a partial implementation. The “Z” bit is the read/write bit for the serial bus transaction.
The thermal sensing device internally decodes 1 of 3 upper address patterns from the bus of the form “0011XXXZb”, “1001XXXZb” or “0101XXXZb”. The device’s addressing, as implemented, uses SMA2 and SMA1 and includes a Hi-Z state for the SMA2 address pin. Therefore, the thermal sensing device supports six unique resulting addresses. To set the Hi-Z state for SMA2, the pin must be left floating. The system should drive SMA1 and SMA0, and will be pulled low (if not driven) by the 10 kΩ pull-down resistor on the processor substrate. Attempting to drive either of these signals to a Hi-Z state would cause ambiguity in the memory device address decode, possibly resulting in the devices not responding, thus timing out or hanging the SMBus. As before, the “Z” bit is the read/write bit for the serial bus transaction.
Figure 6-1shows a logical diagram of the pin connections. Table 6-2and Table 6-3describe the address pin connections and how they affect the addressing of the devices.
Note: Addresses of the form “0000XXXXb” are Reserved and should not be generated by an SMBus master. Also, system management software must be aware of the processor select in the address for the thermal sensing device.
Table 6-2. Thermal Sensing Device SMBus Addressing on the Itanium® 2 Processor
| Address (Hex) | Upper Address1 | Processor Select | 8-Bit Address Word on Serial Bus |
| | | |
| SMA2 | SMA1 | b[7:0] |
| | |
| | | | | |
| 3Xh | 0011 | 0 | 0 | 0011000Xb |
| | | | | |
| | 0011 | 0 | 1 | 0011010Xb |
| | | | | |
| 5Xh | 0101 | Z2 | 0 | 0101001Xb |
| | 0101 | Zb | 1 | 0101011Xb |
| 9Xh | 1001 | 1 | 0 | 1001100Xb |
| | | | | |
| | 1001 | 1 | 1 | 1001110Xb |
| | | | | |
NOTES:
1.Upper address bits are decoded in conjunction with the select pins.
2.A tri-state or “Z” state on this pin is achieved by leaving this pin unconnected.
