Intermec PF4I manual ⇒ Black Mark Width, ⇒ Black Mark Length, ⇒ Black Mark Y-Position

Appendix B—Media Specifications

Tickets with Black Mark ⇐ a ⇒ Media Width

Maximum:	114.3 mm	(4.50 inches)
Minimum (standard):	25.0 mm	(1.00 inches)
Min. (narrow Quick-Load):	40.0 mm	(1.57 inches)
Min. (wide Quick-Load):	80.0 mm	(3.15 inches)

⇐b ⇒ Copy Length

Minimum:	20.0 mm (0.8 inches)
Maximum:	depends on SDRAM size

⇐c ⇒ LSS Detection Position

Five fixed positions, see Chapter 12.

⇐d ⇒ Black Mark Width

The detectable width of the black mark should be at least 5.0 mm (0.2 inches) on either side of the LSS detection point.

⇐e ⇒ Black Mark Length

Maximum:	21.3 mm	(0.83 inches)
Common:	12.5 mm	(0.5 inches)
Minimum:	5.0 mm	(0.2 inches)

⇐f ⇒ Black Mark Y-Position

It is recommended that you place the black mark as close to the front edge of the ticket as possible and use a negative Stop Adjust value to control the media feed, so the tickets can be properly torn off.

Media Type Setup

• Ticket (w mark)

Note: Preprint that may interfere with the detection of the black mark should be avoided. However, the Intermec Fingerprint statement LBLCOND allows the sensor to be temporarily disabled during a specified amount of media feed in order to avoid unintentional detection, see Intermec Finger- print manuals.

Note: The black mark should be non-reflective carbon black on a whitish background. Do not allow any perforations to break the edge of the media as this may cause the media to split and jam the printer.

128 Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint)